What should I do if there is a problem in the use of the Photoeye sensor? How can I reduce the failure of the Photoeye sensor? This is a problem that many users will encounter when using the Photoeye sensor, so how to solve these problems, in fact, many in daily life Note that the use of Photoeye sensor can reduce the occurrence of failures.

Precautions for the use of Photoeye sensor:
1. The front face of the Photoeye sensor in use must be parallel to the surface of the workpiece or object to be detected, so that the conversion efficiency of the Photoeye sensor is high.
2. When installing and soldering, the small distance between the root of the pin of the Photoeye sensor and the pad should not be less than 5mm, otherwise the die will be easily damaged during soldering. Or cause changes in die performance. The welding time should be less than 4 seconds.
3. The small detectable width of the through-beam Photoeye sensor is 80% of the width of the photoelectric switch lens.
4. When using inductive loads (such as lights, motors, etc.), the transient impulse current is relatively large, which may degrade or damage the AC two-wire Photoeye sensor. In this case, please switch the load through an AC relay.
5. The lens of the infrared Photoeye sensor can be wiped with lens cleaning paper, and chemicals such as dilution solvents are prohibited to avoid damage to the plastic lens.
6. In accordance with the actual requirements of users on site, under some harsh conditions, such as dusty occasions, the sensitivity of the Photoeye sensor produced has increased by 50% to adapt to the prolonged maintenance period of the Photoeye sensor in long-term use. Requirements.
7. The Photoeye sensor must be installed where there is no direct irradiation of strong light, because the infrared light in the strong light will affect the normal operation of the receiving tube.
With the development of the times, the frequency of use of the Photoeye sensor has gradually increased. I hope that after reading the introduction of the editor, you can pay attention to the problems that may be encountered in the use of the Photoeye sensor, and reduce the failures that may occur during the use of the Photoeye sensor.